White Freebird TKL, Keycult no 2 Plate/PCB, Hull jetvan plate, Keycult x Grovemade Deskpad

Description

Timestamp

Prices include shipping CONUS, willing to exchange locally at the upcoming Castle Pines meetup as well, or elsewhere around Denver.

Selling some extra pcbs/plates and a board I don't use anymore.
First up, selling a UHMWPE plate for a keycult no 2 tkl (has the holes for the alignment pins), along with either a solder or hotswap pcb. Both pcbs have been opened to test. Hotswap pcb was tested by shorting the contacts on the back, not putting switches in. Solder pcb was tested by shorting where the switches would be. I think I might have used the hotswap pcb previously, but the solder is unused.

Will include the longer cable (currently in solder bag, used for no 2) with whichever gets chosen.
Plate + either PCB 110 Shipped CONUS

Hull Jetvan plate: 20$ shipped CONUS

Keycult x Grovemade deskmat: 90, local only. Badge was sandblasted and clear coated. This has been used, there's some signs of it but nothing I would classify as major. Hard to photograph.

Freebird:

More photos from previous post

I received this moderately beat up from the previous owner - there's some marks along the sides, some of the visual flaws are from the tape from the force break mod the previous owner applied peaking out of the edges. Please look at the previous post photos. I have non-original screws currently installed that are T6 head, that work fine, as well as the silicone dampening pad and original o-ring. Will not come in a case. Previous owner did not include the original plate screws.

These pcbs/plates were previously used in a jane v2 ME

Comes with White Delrin and Stainless steel plates from Ponoko.
PCBS are my custom ordered pcbs with This support in both alps and MX except with F13 top row rather than F12 (no rotated top row for AEK). Both plates are cut to support all layouts the pcbs do in MX.

The pcb with the stainless steel plate is millmaxed for \all\ of these layouts for MX switches, but this does require some modifications to the stabilizers for some of the keys to allow them to sit flat on top of the millmax sockets. Pressing down too hard on the alpha section of this combo when built may result in it becoming misaligned and the pcb slipping off the top row. This requires continuous force beyond typical use, but does require opening the build to address/fix when it happens. It does not usually disconnect the top row but does make things look weird. The stabs are currently placed and modified for the nonstandard layout I use. Will ship held in place with the box royals currently in it.

The other pcb is desoldered, but has been tested since soldering.

Asking 160 for the board with both pcbs and plates.

Previous Post