Flex cut 60% and 65% PCB's
User: chungsteroonie
Confirmed trades: 2
Posted: 2022-03-08 00:12:37 (UTC)
Listing Type: Selling
Region: US
Subregion: CA
Description
Timestamp
60% - $40 plus actual shipping cost
65% - $40 plus actual shipping cost
These two PCB's are left over from my tinkering and modifications of open source PCB projects. They are new, have VIA firmware installed, and all keys have been tested with tweezers.
The 60% board is a Plain60 flex edition with 4 flex cuts as well as added provisions for both the open source bakeneko 60 rev. 3 support spacing as well as the Cannonkeys (Unikorn) spacing. The MCU and resonator crystal were hand soldered with detail in the timestamp. It it configured for USB C connector and tested as such, but has provisions for a JST connector although it is not soldered on. Note, the position of the JST connector has been shifted to make room for the flex cut so clearances might be effected. If you were to use this board for a Bakeneko, you would need to remove the USB connector and solder in a JST connector.
The 65% PCB is the open source Bakeneko 65 with two flex cuts added. The MCU and JST connectors were hand soldered with detail photo in the timestamp. The JST connector location has been shifted to accommodate the flex cut. Please note, this may effect cable length as well as clearances in the Bakeneko 65.